Whiteline Rear Lower Control Arm Bushings for Civic/CR-V

Whiteline Rear Lower Control Arm Bushings for Civic/CR-V

The Whiteline Rear Lower Control Arm Outer Bushing Kit replaces the factory bonded rubber bushings at the outer joint of the rear lower control arm, where the arm attaches at the knuckle end. In this location the bushing primarily controls rear toe and camber stability under braking and cornering load by limiting unwanted compliance at the control arm pivot.

In factory form, rubber bushings are designed for isolation and can soften further with age, heat, and contamination. As the rubber degrades, the rear suspension can develop additional dynamic movement at the arm to knuckle interface, which can contribute to reduced consistency in alignment under load. This kit is intended as a direct replacement bushing set for that outer position rather than a geometry correction part.

W63382 uses Whiteline synthetic elastomer polyurethane bushings and includes metal sleeves plus supplied lubricant. The kit is produced in two sleeve sizes, matching applications that use either approximately 12.2 millimeter or 14.3 millimeter inner sleeve diameters. The bushing outer diameter is listed as 43.5 millimeter. No mounting hardware is included.

Key Features

• Location rear lower control arm outer position
• Material polyurethane synthetic elastomer
• Kit quantity 8 bushings
• Bushing outer diameter 43.5 millimeter
• Inner sleeve diameters 14.3 millimeter and 12.2 millimeter
• Lubricant supplied grease

Fitment

• Verified fitment Honda Civic 7th generation 2001 to 2005
• Verified fitment Honda CR V chassis codes RD1 through RD7