Seibon Carbon Fiber Fenders for 00-09 Honda S2000

  • Fits 2000-2009 Honda S2000

  • Lightweight carbon fiber construction

  • Hand-laid for superior quality

  • Factory gel coat for protection

$1,440.00

/
Subscription
Availability needs to be checked. See the message below. Currently out of stock Available to order In stock · available Available to order

Part # SCN-FF0005HDS2K

Vehicle compatibility

Check compatibility with your vehicle.

Description

Seibon Carbon Fiber Fenders for 00-09 Honda S2000 (AP1/AP2)

Put wider tires or a more aggressive wheel offset on an S2000 and you'll find out fast how little room there is up front. Turn the wheel at full lock or hit a big dip and the tire catches the fender lip. Rolling or pulling the factory fenders can buy you a few millimeters, but it can crack the paint, and you can't undo it. Seibon's wider fenders handle it a different way. They're shaped like the factory fenders but sit 10mm wider, so the front tires get more room without any cutting or rolling.

That's the real reason to buy these. If you're running a wider front tire for track days or autocross, or wheels with a more aggressive offset for a flush stance, 10mm can be the difference between rubbing and not rubbing. They're carbon, so they also take a little weight off the nose. It's a modest change, not a widebody kit. The car still looks like an S2000, just with a little more fender over the front wheels. If you're running stock wheels and tires, Seibon's standard-width fenders are a better match.

How Much Room You Actually Get

Each fender is 10mm wider than stock. That's roughly enough to cover one size wider tire, or a lower offset that pushes the wheel out about the same amount. The exact clearance depends on your wheel, tire, offset, ride height, and alignment. Test-fit your setup with the suspension compressed and the steering at full lock before you call it done. If your setup already rubs badly on the factory fenders, 10mm might not be enough by itself.

Wet Carbon, Hand Laid

Each fender is laid by hand using wet carbon. The carbon cloth goes into the mold and is soaked with liquid resin, instead of using pre-impregnated sheets cured under pressure in an autoclave. Wet carbon is a bit heavier than autoclave "dry" carbon and costs a lot less, so most aftermarket carbon body panels are made this way. Seibon applies a clear gel coat at the factory, so the fenders are ready to bolt on, and every fender is inspected before it ships. Wax or ceramic coat them like you would paint, so UV doesn't yellow the carbon over time.

Install Notes

They bolt on where the factory fenders go and reuse your factory side markers, trim, and fender liners. Hang each fender loosely, then work the gaps to the hood, door, and bumper before you tighten anything. Since these sit wider than stock, pay close attention to where the fender meets the bumper so the transition looks even on both sides. Have a second person help you, and don't over-tighten bolts that thread into carbon. Snug and even is enough. Once they're on, recheck tire clearance at full lock both ways.

Fitment

  • 2000-2009 Honda S2000 (AP1/AP2)
  • 2008-2009 Honda S2000 CR
  • Front fenders, 10mm wider than stock
  • Reuses factory lighting, trim, and fender liners
FITMENT

2000-2005 Honda S2000


2006-2009 Honda S2000


YOU MAY ALSO LIKE

RECENTLY VIEWED