Product images 1 / 1
Description
Revel Medallion Street Plus Catback Exhaust - 2000-2009 Honda S2000
The S2000's F-series engine revs to the moon and makes its power right at the top, and the factory exhaust is both heavier and more restrictive than a car built around that deserves. The Revel Medallion Street Plus is a full catback that replaces everything from the catalytic converter back with 60mm SUS304 piping, so the exhaust gas keeps moving freely instead of being choked down through the stock muffler. On a motor that lives above 6,000 rpm, that freer flow is exactly what lets it pull cleaner through the top of the range where the S2000 comes alive.
Be realistic about the power side. A catback on a naturally aspirated F-series is not a big horsepower adder on its own, and the honest gains come when it's paired with intake and header work. What this system does well is free up flow, drop weight over the heavy factory exhaust, and give the car the sound and the look it deserves. For a lot of S2000 owners, that change in character is the real reason to do it, with the flow improvement as a bonus.
Sound: Deep, but Kept Civil
This is the Street Plus, tuned for a deeper, more purposeful tone that still stays livable. Revel tests it under 93dB, so you get a rich, low-frequency note with real presence rather than the harsh rasp or constant drone that plagues cheaper exhausts. The continuous-strand ADVANTEX packing inside the oval canister is central to that, suppressing the sharp high frequencies while still flowing well, so the car sounds aggressive when you're on it and settles down to something you can live with on a daily drive and a long highway cruise.
Build and Looks
The system is full SUS304 stainless steel, so it resists corrosion and holds up to years of heat cycles and weather without rotting out the way mild-steel exhausts do. The slim-line oval canister is shaped to tuck up and keep ground clearance high, which matters on an S2000 sitting on coilovers or lowering springs, so you're less likely to scrape on driveways and speed bumps. It finishes in a polished 100mm dual-wall angle-cut tip that gives the back of the car a clean, aggressive look with the extra strength and finish double-wall construction brings.
Fitment
This catback fits the 2000-2009 Honda S2000, both the AP1 (F20C) and the AP2 (F22C). It's a direct bolt-on that replaces the factory system from the cat back using the stock hanger locations, so no cutting or fabrication is needed on an otherwise stock car.
Installation Notes
Installation is a straightforward bolt-on job using the factory hangers and flange. Fresh gaskets and hardware at the cat flange make for a leak-free seal, and it's worth leaving the clamps loose until the whole system is hung and aligned so the tip sits centered in the bumper before you torque everything down.
FITMENT
2000-2009 Honda S2000