Insane Shafts 500 HP 36mm Conversion K Swap Axles for EF Civic/CRX

  • Heat-Treated Chromoly, Rated to 500 WHP

  • Built for 36mm 5-Lug Conversion

  • Requires the Insane Shafts Intermediate Shaft

  • Compatible Lengths for EF Civic and CRX K Swaps

$690.00

/
Subscription
Availability needs to be checked. See the message below. Currently out of stock Available to order In stock · available Available to order

Part # IS-047-048

Vehicle compatibility

Check compatibility with your vehicle.

Description

Insane Shafts 500 HP 36mm Conversion K-Swap Axles - 1988-1991 Honda Civic / CRX (EF)

When you K-swap an EF Civic or CRX, the axles become one of the weak points if you don't address them, because a modern K-series makes far more torque than anything the chassis was built to put down. These are Insane Shafts' 500 HP conversion axles, built specifically for an EF running a K-series swap with the 36mm 5-lug hub conversion. They're a long step up from typical swap axles, made to take the power a built K20 or K24 puts through them without becoming the thing that lets go on a hard launch.

Built to Hold 500 Wheel Horsepower

The shafts are made from chromoly steel and run through Insane Shafts' own annealing and heat-treatment process, which is what lets them handle up to 500 wheel horsepower. Chromoly on its own is strong, but it's the heat treatment that sets the balance between hardness and the ability to flex and twist under shock loads without cracking. That matters on a light EF making real power, where the axles see sudden hits every time the tires hook, and it's the difference between an axle that survives and one that snaps at the worst moment.

Made for the 36mm 5-Lug Conversion

Read the fitment carefully, because this is a specific build. These axles are cut for an EF Civic/CRX that has been K-swapped and converted to the 36mm 5-lug setup. If your car isn't running that exact hub and conversion spec, these aren't the right axles, so confirm your build matches before ordering. For anything outside this application, Insane Shafts can handle custom setups.

You'll Need the Intermediate Shaft

A K-swap axle setup uses an intermediate shaft on the passenger side, and this application calls for the Insane Shafts K-Series MT intermediate shaft (IS-BRK-2). If you don't already have it, add it to complete the setup: Insane Shafts K-Series MT Intermediate Shaft.

What's Included

The axles come with removable ABS rings where applicable, along with new spindle nuts, so you have the hardware to finish the install rather than reusing stretched old nuts on a critical fastener.

Fitment

Fits the 1988-1991 Honda Civic and CRX (EF) with a K-series swap and the 36mm 5-lug conversion.

Installation Notes

These are a direct fit for the application they're built for, so no modification is needed when your build matches the spec. Torque the new spindle nuts to spec and stake them properly, since that's what keeps the hub assembly tight, and confirm your intermediate shaft is in place before final assembly.

FITMENT

1988-1991 Honda Civic
1988-1991 Honda CRX

IN THE BOX

(2) Axles, Driver and Passenger Sides

YOU MAY ALSO LIKE

RECENTLY VIEWED