Product images 1 / 1
Description
InlinePro EGR Block-Off Plate - 2000-2009 Honda S2000
The EGR system routes a small amount of exhaust gas back into the intake to lower combustion temperatures and cut emissions. It does its job on a stock street car, but once you start working on the engine it becomes a passage a lot of people would rather seal off. This InlinePro block-off plate caps the EGR port cleanly, which is why it tends to go on during intake manifold swaps, header work, or any build where you want exhaust gas kept out of the intake side and the engine bay tidied up.
There are two reasons people run one. The first is a cleaner setup: blocking the EGR keeps recirculated exhaust and the carbon it leaves behind out of your intake tract. The second is simply the look, since a machined billet plate finishes off that part of the engine far better than the factory hardware. On a lot of aftermarket intake manifolds the EGR provision isn't there anyway, and this is the plate that seals the port when you make that switch.
Built from Billet, Black Anodized
The plate is machined from 6061 billet aluminum, so it's solid, flat, and seals properly against the port rather than warping or weeping over time. It's finished in a black anodized coating that resists corrosion and gives it a clean, understated look under the hood instead of raw metal. All the mounting hardware is included, with flush-mount stainless fasteners that sit clean against the plate and won't rust where they're exposed to engine heat and weather.
An Honest Note on EGR Deletes
Be aware of what blocking the EGR means for your car. Depending on your exact setup and tune, deleting the EGR function can set a check engine light or call for tuning to clear it. EGR deletes are generally intended for off-road and race use, and they may not be emissions-legal where you live, so check your local laws before you run one on a street-driven car.
Fitment
This EGR block-off plate fits the 2000-2009 Honda S2000.
Installation Notes
Installation is straightforward: remove the factory EGR hardware, clean the mating surface so the plate seats flat, and bolt the plate down with the included stainless hardware. A fresh gasket or sealant at the surface makes for a clean seal, and snug the hardware evenly so the plate sits flush against the port.
FITMENT
2000-2009 Honda S2000