Description
Hybrid Racing MAP Sensor Port Plug
Hybrid Racing throttle bodies include a MAP sensor port, but plenty of setups don't use it. If you're reading manifold pressure somewhere else, running a boosted or standalone setup, or just simplifying the engine, that port ends up as an open hole on the throttle body. Left open, it's an unmetered air leak, and an air leak shows up as a rough idle, a lean condition, and tuning that won't settle down. This plug seals the port off cleanly so none of that happens.
Seals the Port, No Leaks
The plug is machined from anodized aluminum, so it's strong, corrosion-resistant, and finished to match the look of the throttle body rather than looking like a shop-made cap. It comes with the mounting hardware and an O-ring, and the O-ring is what actually does the sealing, giving you a tight, leak-free blockoff instead of relying on thread sealant or hoping a bare plug seats flat.
Fitment
This plug was designed for the Hybrid Racing 75mm throttle body, where it's a precise, purpose-built fit. It may also work on other aftermarket throttle bodies with a similar MAP port, but since those vary, check your port before counting on it if you're running something other than the HR throttle body.
Installation Notes
Installation is quick: make sure the port and the O-ring seat are clean, set the O-ring in place, and bolt the plug down evenly with the included hardware so it sits flush and seals all the way around. With the port blocked, there's no unmetered air sneaking in and nothing for your tune to fight.