Honda K24Z/L15B7 Transmission Case Sealing Bolt 90081-RPF-000

  • Genuine Honda Product

  • Seals the Countershaft Snap Ring Access Port

  • 32mm Bolt with Pre-Applied Thread Sealant

  • Fits K24Z, L15B7, and R18A Transmissions

$20.23

/
Subscription
Availability needs to be checked. See the message below. Currently out of stock Available to order In stock · available Available to order

Part # OHA-90081-RPF-000

Vehicle compatibility

Check compatibility with your vehicle.

Description

Honda Transmission Case Sealing Bolt - K20C / K24Z (90081-RPF-000)

This is the sealing bolt that threads into the transmission case to close off the access port at the countershaft snap ring (90601-PPP-000). That port is how you reach the snap ring that retains the countershaft during a rebuild, and once the shaft is serviced, this 32mm bolt seals the opening back up and keeps the gear oil where it belongs. It's a small part, but it's the one holding the oil in at that spot, so a proper seal here is the difference between a clean transmission and a slow leak down the side of the case.

Pre-Applied Thread Sealant

The bolt comes with thread sealant already applied, so it's ready to seal as soon as it goes in, with no need to add your own. Because that sealant is meant for a single install, it's worth fitting a fresh bolt whenever you've had the case open rather than reusing the old one, since reused sealant won't seal as reliably the second time around. At this price, a new one is cheap insurance against a leak you'd otherwise have to pull the trans back out to fix.

When You Need One

You'll reach for this bolt any time you're into the transmission at the countershaft snap ring, whether you're rebuilding, swapping internals, or chasing a leak traced back to this sealing point. It's also the right call if the existing bolt is rounded off, cross-threaded, or weeping, since replacing it is far simpler than living with a seep.

Genuine Honda

This is a genuine Honda OEM bolt, so the thread pitch, the sealing design, and the pre-applied sealant all match what the case was built for, rather than a generic hardware-store substitute that may not seal against gear oil pressure.

Fitment

Fits the manual transmissions in the following K20C and K24Z applications:

  • 2013-2015 Acura ILX
  • 2023-2026 Acura Integra A-Spec
  • 2009-2014 Acura TSX
  • 2008-2017 Honda Accord
  • 2018-2020 Honda Accord 1.5T
  • 2006-2015 Honda Civic DX / EX / LX
  • 2009-2015 Honda Civic Si
  • 2016-2021 Honda Civic LX
  • 2017-2020 Honda Civic Si
  • 2022-2027 Honda Civic Si
  • 2011-2016 Honda CR-Z
  • 2009-2010 Honda Element
  • 2015-2020 Honda Fit
  • 2016-2018 Honda HR-V

All of these are manual-transmission applications.

FITMENT

2013-2015 Acura ILX
2023-2026 Acura Integra A-Spec
2009-2014 Acura TSX
2008-2017 Honda Accord
2018-2020 Honda Accord 1.5T
2006-2015 Honda Civic DX / EX / LX
2009-2015 Honda Civic Si
2016-2021 Honda Civic LX
2017-2020 Honda Civic Si
2022-2027 Honda Civic Si
2011-2016 Honda CR-Z
2009-2010 Honda Element
2015-2020 Honda Fit
2016-2018 Honda HR-V

YOU MAY ALSO LIKE

RECENTLY VIEWED