Honda 2 Inch/50mm Oil Seal Driver Tool 07NAD-P20A100

Honda 2 Inch / 50mm Oil Seal Driver Tool - Genuine OEM (07NAD-P20A100)

Ever tap an oil seal in with a socket and a prayer, only to have it go in crooked and start weeping a week later? Yeah, don't do that. This genuine Honda oil seal driver is how you seat a 50mm seal the right way, dead flush and square, the first time. It's a 2 inch (50mm) diameter driver that pushes the seal in evenly across its whole face, so you're not cocking it, skewing it, or nicking it on the way in.

Why The Right Driver Actually Matters

Here's the deal with oil seals. They have to go into their bore perfectly square and to the right depth, or they leak, it's that simple. Try to drive one in with a socket, a punch, or the wrong-size tool and it's easy to push it in crooked, distort it, or damage the sealing lip, and then you're pulling it back out and buying another one to try again. This driver matches the seal at a proper 50mm face, so when you tap it home it goes straight in, flat, and to depth in one clean shot. Do it right once instead of fighting it three times.

How It Works

This is the 50mm driver attachment, and it's made to run with the Honda bearing and seal driver handle, part 07746-0030100. You thread or seat this driver onto that handle, set it against your seal, and tap the handle with a hammer to drive the seal in square. Heads-up on that: you need the 07746-0030100 driver handle to use this attachment, so if you don't already have it, grab one, since this piece isn't meant to be used on its own.

What You Get

• Genuine Honda oil seal driver tool (07NAD-P20A100)
• 2 inch (50mm) diameter driver face for 50mm oil seals
• Seats seals flush and square, without skewing or damaging them
• Works with the Honda driver handle 07746-0030100 (required, sold separately)
• Genuine Honda special tool

Note: Genuine Honda oil seal driver tool, part number 07NAD-P20A100, with a 2 inch (50mm) diameter driver face for installing 50mm oil seals. It seats seals squarely and flush at the correct depth, preventing the skewing, distortion, or lip damage that causes leaks when seals are installed with improper tools. This is the driver attachment and is used with the Honda bearing and seal driver handle, part number 07746-0030100, which is required to use it and is sold separately. One driver tool per order.