BC Racing BR Series Coilovers for 08-12 Accord/09-14 TSX

BC Racing BR Series Coilovers - 2008-2012 Honda Accord / 2009-2014 Acura TSX (A-26-BR)

The 8th gen Accord and the TSX are easy cars to live with, but they ride soft and tall straight off the lot, and after this many years the factory struts are usually cooked. The BC Racing BR Series is the fix most owners reach for. It's the cheapest coilover BC makes, and it hands you the two things you're after: a clean drop you set yourself, and damping you can turn from soft-and-comfy to firm-and-sharp whenever you want. BC's been building these since the early 2000s, and the BR is the one they sell more of than anything else. Bolt it on, set your height, and your Accord or TSX loses the fender gap and the float in one shot.

Here's What Tired Stock Suspension Is Costing You

A worn-out Accord or TSX gives itself away. It floats over dips, the nose dives when you brake, and the body leans through corners instead of staying flat. These are heavier sedans, so once the factory dampers give out, all that weight just wallows around on you. And you're stuck sitting up in the fenders, because the stock springs only sit one place. Coilovers fix both. You'll get firm, adjustable damping that keeps the body planted and the tires down, plus the height set wherever you like it. The car feels tighter and more buttoned-down the first time you pull out of the driveway.

Spring Rates BC Tuned For This Car

Here's what sets the BR apart from the bargain coilovers. BC didn't just throw a stiff spring on it and call it done. They tested this kit on the car and picked rates that hold the body flat without beating you up on a rough road, so you're not stuck with the oversprung ride a lot of cheap kits give you. Underneath it's a 53mm mono-tube shock with a linear piston and damping curve, a real damper you'll rebuild down the road instead of tossing once it wears. BC's concave lower locking ring keeps your height from creeping once it's set, and pillowball top mounts sharpen up the steering so the front end goes where you point it.

30 Clicks, Soft For The Commute Or Firm When You Want It

You get 30 clicks of compression and rebound off a single knob, so you're never stuck with one feel. Want it plush for the daily grind? Back it off. Heading somewhere you can actually drive it? Firm it up in a couple minutes. Height adjusts on its own thread, separate from the spring, so you'll sit low without giving up all your shock travel. And the BR grows with you. If the tuning bug bites later, you can spec custom spring rates, Swift springs, or matched valving without buying a whole new kit. The rear adjusters tuck up out of easy reach on these, so BC's got rear damping extenders if you'd rather not dig for them every time.

Fits The 8th Gen Accord And The TSX

This one covers the 2008-2012 Honda Accord, sedan and coupe, and the 2009-2014 Acura TSX. Coilovers bolt to the chassis, so the same A-26-BR fits across both, whether you've got the four-cylinder or the V6. One honest heads-up: any time you drop a car this much, get an alignment afterward to set your camber and toe and keep your tire wear even. BC's got front and rear camber plates available if you want more adjustment than the stock hardware gives you.

What You Get

• BC Racing BR Series coilover kit (A-26-BR) for the 8th gen Accord / 2nd gen TSX
• 53mm mono-tube shock design with a linear piston and damping curve
• 30 clicks of simultaneous compression/rebound adjustment
• Ride height adjustable independent of spring compression
• BC's concave lower locking ring to hold your height setting
• Pillowball top mounts for sharper steering
• Standard spring rates: 10kg front, 4kg rear
• Sits about 1 inch below stock at the highest setting, 2.5 to 3 inches at the lowest
• Front and rear camber plates available
• Custom spring rates, Swift springs, and custom valving available
• Rear damping extenders available
• Fully rebuildable
• 2-year warranty against manufacturer defect

Fits These Cars

• 2008-2012 Honda Accord (8th gen), sedan and coupe
• 2009-2014 Acura TSX (2nd gen), K24 and V6

Note: BC Racing BR Series coilover system (SKU A-26-BR) for the 2008-2012 Honda Accord and 2009-2014 Acura TSX, chassis CP2, CP3, CS1, CS2, and CU. Built on a 53mm mono-tube shock with a linear piston and damping curve, with 30 clicks of simultaneous compression/rebound adjustment. Ride height adjusts independent of spring compression and locks in with BC's concave lower locking ring, sitting about 1 inch below OEM at the highest setting and 2.5 to 3 inches below at the lowest. Standard spring rates are 10kg front and 4kg rear, tuned by BC for a balance of comfort and handling rather than an oversprung ride. Pillowball top mounts included, with front and rear camber plates, custom spring rates, Swift springs, custom valving, and rear damping extenders offered. Fully rebuildable and backed by a 2-year warranty against manufacturer defect. Fits both the four-cylinder and V6. One coilover kit per order.