PRODUCT DETAILS
Honda AP2 S2000 Taillight Gasket - Genuine OEM (33502-S2A-A11 / 33552-S2A-A11)
If you've ever pulled a taillight on your AP2 and found the foam gasket behind it crumbling, flattened, or barely there anymore, this is the fix. These are the genuine Honda taillight gaskets for the 2004-2009 S2000, the foam seals that sit between your taillight and the body and keep water from sneaking in behind the lens. They come with the glue already on them, so once you peel the backing and set the light, they bond right to the car and seal it up tight. After twenty-some years, the original foam on most of these cars is shot, and a fresh gasket is the difference between a dry trunk and a slow leak you'll be chasing for months.
Why This Little Foam Seal Actually Matters
It doesn't look like much, but this gasket is the only thing standing between your taillight opening and the weather. When the foam dries out, shrinks, or gets torn during a light swap, water starts working its way past it, and on an S2000 that means moisture in the trunk, fogging inside the lens, and over enough time, rust forming around the taillight buckets where you can't see it until it's a real problem. None of that announces itself right away either, you just notice a damp spare tire well one day and start wondering where it's coming from. Replacing the gasket while you've got the light off is cheap insurance against all of it.
Foam Build With The Glue Already On It
These are the correct foam-construction gaskets Honda used from the factory, shaped to match the AP2 taillight exactly. The best part is the adhesive is already applied, so there's no hunting for the right sealant or making a mess with a tube of something. You clean the surface, peel the backing, line the gasket up, and press the light into place. The glue bonds it to the body so it stays put and seals against moisture the way it's supposed to. Clean surface, firm press, done, it's about as easy as a seal gets.
Order The Side You Need, Or Both
These are side-specific, so make sure you grab the right one. The passenger side is 33502-S2A-A11 and the driver side is 33552-S2A-A11. If you're only chasing a leak on one corner you can do just that side, but honestly, if one gasket's this worn the other usually isn't far behind, so a lot of people do both at once while they're back there. Up to you and what your car needs.
What You Get
- Genuine Honda AP2 S2000 taillight gasket
- Passenger side: 33502-S2A-A11
- Driver side: 33552-S2A-A11
- Foam construction with pre-applied adhesive
- Seals the taillight to the body against moisture
- Direct OEM replacement
- Sold individually, order the side(s) you need
Fits These Cars
- 2004-2009 Honda S2000 (AP2)
Note: Genuine Honda taillight gasket for the 2004-2009 Honda S2000 (AP2). Foam construction with pre-applied adhesive that bonds to the body to seal the taillight against moisture. A worn or torn gasket can let water into the trunk area and lead to fogging and rust around the taillight buckets. Side-specific: passenger side is part number 33502-S2A-A11 and driver side is part number 33552-S2A-A11. Install on a clean surface by peeling the backing and pressing the taillight into place. Sold individually, order the side or sides you need. One gasket per order.