Rywire Engine Harness (K-Series) Install Guide

Connect the Hybrid Racing coolant temp wire to Rywire H20 pin 6 for EG/DC/EK gauge cluster control. Use the Extra wires (C101 pins 11 & 12) for an additional sensor after confirming continuity.

Rywire K-Series engine harness coiled on white background with black braided wires and multi-color connectors.
Cover view of the complete Rywire engine harness for Honda K-Series, showing the full loom and labeled connectors.
Difficulty
Moderate
Steps
2
Time required
30 min
Category
Electronics

This guide covers connecting the Hybrid Racing coolant temp wire to pin 6 on the Rywire engine harness H20 connector for EG/DC/EK gauge cluster control, and using the Extra wires at C101 pins 11 and 12 for an additional sensor after confirming continuity.

01 Coolant Temp / H20 Sensor

Connector pinout diagram with pin 6 highlighted in red for the coolant temp sensor.
Locate pin 6 on the Rywire engine harness H20 connector for the coolant temp sensor wire.
Black braided H20 connector from the Rywire engine harness for the coolant temp sensor.
Note the connector labeled H20 on the Rywire engine harness for the coolant temp sensor.
  1. On the Rywire engine harness, there is a connector labeled H20. This normally connects to the gauge cluster temp sensor located on the upper water neck on the Honda K20.
  2. The Hybrid Racing conversion harness has a wire labeled "coolant temp." In order to control the gauge cluster in the EG/DC/EK chassis, you'll need to connect the wire labeled "coolant temp" to pin 6 on the Rywire engine harness.

02 "EXTRA" Wire

C101 connector pin diagram with pins 11 and 12 highlighted as EXTRA on the Rywire engine harness.
Pins 11 and 12 on the C101 connector are the extra wires for an additional sensor.
Braided black EXTRA wire from the Rywire K-series engine harness ending in two bare leads.
Look at the EXTRA-labeled wire with its two exposed ends for the optional external sensor connection.
  1. The Rywire engine harness has an "Extra" wire included in the harness.
  2. This can be used to control or display an additional external sensor, such as a boost controller, air pressure sensor, etc.
  3. There are two wires on the engine harness, they correspond with the C101 connector, pins 11 & 12.
  4. Be sure to check the continuity between each wire to confirm the pin locations as they are not labeled.

Finishing up

Confirm continuity between each Extra wire and C101 pins 11 and 12, as the pins are not labeled. Ensure the Hybrid Racing coolant temp wire is connected to pin 6 on the Rywire H20 connector for EG/DC/EK gauge cluster control.